Danny Mitchell wrote:Tony Russell Davis wrote:I tune each note on the steel guitar (pedal or non) by listening to it within the major chord it's in Then check the minors, which are usually right by then.
. . . if I understand correctly, after tuning a reference E, you'll tune the B strings while holding a Bmajor (in it's different inversions?) up the neck, then on through the other strings before changing to minor chords?
Yes, just about, but I only tune the open strings, not up the neck. On an E9th pedal guitar, as you say, I tune all the strings that make an E chord, then the D# and both F#s referenced from the B already tuned. Then it's only the D (9th) against an F#. Then I listen to the D as a 7th in case it needs tweaking. All the pedals are then tuned by ear holding a "pedals-down" chord and referenced to an already tuned open note or an already tuned pull; all at the nut position. The easiest example is tuning A and B pedals together against the E. Then it's B and Es lower for the 7th; A and Es raise for the inversion, etc. So it's all done by hearing that the chord I play, whatever it is, sounds right.



