Page 1 of 1
Replacement screw for Goodrich VP
Posted:
Sun Jun 08, 2014 6:46 pmby saddletramp
I need a new screw to replace the one that holds the end of the cord that rotates the pot shaft in a Goodrich 120 VP, the end attached to the angle bracket. Presumably this will be an imperial (US) thread. Does anyone know where I might look for one?
Cheers,
Chris
Re: Replacement screw for Goodrich VP
Posted:
Mon Jun 09, 2014 9:58 amby Malcolm
Chris take it into any good hardware or engineering supply company , they should be able sort one out for you, or check with Bob Adams, sure he could help.
Re: Replacement screw for Goodrich VP
Posted:
Mon Jun 09, 2014 6:23 pmby saddletramp
Thanks, Malcolm. I'll do that. Good, old fashioned hardware stores are hard to come by nowadays.
Re: Replacement screw for Goodrich VP
Posted:
Tue Jun 10, 2014 10:58 amby Jason Lynch
I've a few imperial sized bolts here. Have a rough measure of the size and I'll see what I have that matches.
Re: Replacement screw for Goodrich VP
Posted:
Tue Jun 10, 2014 5:37 pmby saddletramp
Thanks for the offer, Jason. I have managed to get a suitable replacement from work.
Cheers,
Chris