Help with a Small Bennett Part
Posted: Fri Aug 13, 2021 4:00 pmHi everyone, I’m hoping someone call help me out.
I’ve recently been brave enough to start fiddling with the underside of my steel but I’ve run into a problem. I’ve managed to buckle a couple of locking barrels that attach the pull rods to the bell crank finger (see picture). It seems that if I don’t tighten them enough the rods will just spin when I try to tune them, but if I tighten them too much they break!
I was told Ronnie Bennett installed the mechanics - I’ve been struggling to find replacement parts. My measurements with the vernier come out at about 4.7mm diameter but these are the closest things I can find:
https://www.psgparts.com/Barrel-Locking-Rod-Brass-BBL-250.htm
https://www.psgparts.com/Pull-4-Hole-02-060.htm
Does anyone know where I could find the right parts or have any advice? It would be very much appreciated! Cheers all.
I’ve recently been brave enough to start fiddling with the underside of my steel but I’ve run into a problem. I’ve managed to buckle a couple of locking barrels that attach the pull rods to the bell crank finger (see picture). It seems that if I don’t tighten them enough the rods will just spin when I try to tune them, but if I tighten them too much they break!
I was told Ronnie Bennett installed the mechanics - I’ve been struggling to find replacement parts. My measurements with the vernier come out at about 4.7mm diameter but these are the closest things I can find:
https://www.psgparts.com/Barrel-Locking-Rod-Brass-BBL-250.htm
https://www.psgparts.com/Pull-4-Hole-02-060.htm
Does anyone know where I could find the right parts or have any advice? It would be very much appreciated! Cheers all.
