Page 1 of 1
Any idea where to find these clamps?
Posted: Thu Feb 27, 2020 10:21 pm
by cattlegrid_79
Hi all
I've just dragged my old steel out of the cupboard for the first time in years. I have a couple of clamps missing for the push pull rods. Anyone know where I can get some more? Pic attached (hopefully)
[m
Re: Any idea where to find these clamps?
Posted: Fri Feb 28, 2020 1:42 pm
by Jim Pritchard
They look like they came out of electrical connector choc blocks. Iv'e seen these inserts used before, for this application.
Find one or two that fits your rods & remove the screws & push out the connector, and there you have it
Re: Any idea where to find these clamps?
Posted: Fri Mar 13, 2020 1:16 am
by cattlegrid_79
Nice one. I didn't think of that, but yes, they do look spookily similar. Thanks!
Re: Any idea where to find these clamps?
Posted: Sat Mar 14, 2020 7:30 am
by JohnDavisStringsHere
Not very nice to look at for under a steel, if its standard 3mm rod PM full name and address and I will post you some "Emmons type" locks