Tips wanted on Pedal set-up....

[bob adams]

Yip, Spot on Richard and i had all that written on my reply then cut it as I thought I was going to over complicate the issue! Hope you get sorted out Kev!

[tonewheelkev]

Thanks for all responses so far....some of the springs definitely need looking at...!

Will report back, but will most likely be Thursday before I can get some time for 'hands - on'!!

[Tony Russell Davis]

So how have you got on Kev? (and you're not quite alone here in N.Yorks, I'm near Leeming Bar on A1).
Just to elaborate the reason for the pedal height thing - the pedal height needs to be set so that your foot can "hover" over A+B, but can also press either one (inside or outside edge of sole) without fouling the other. You move to get B and C but a similar ergonomic applies. That's why A is higher than B, and C about level with A; in an Emmons setup.
You've had some posts already so I'm assuming it's an all-pull and you've set the "hard" stops as Bob told you. Your 2nd string lower issue - check the stops again, in case the pull rod does not have sufficient travel for that change. And make sure the crank is tight on the cross shaft.
PM me for a tel.no. if you want to talk or meet.
All best, Tony.