Any idea where to find these clamps?

[cattlegrid_79]

Hi all

I've just dragged my old steel out of the cupboard for the first time in years. I have a couple of clamps missing for the push pull rods. Anyone know where I can get some more? Pic attached (hopefully)

[m

Attachments

[Jim Pritchard]

They look like they came out of electrical connector choc blocks. Iv'e seen these inserts used before, for this application.
Find one or two that fits your rods & remove the screws & push out the connector, and there you have it

Attachments

[cattlegrid_79]

Nice one. I didn't think of that, but yes, they do look spookily similar. Thanks!

[JohnDavisStringsHere]

Not very nice to look at for under a steel, if its standard 3mm rod PM full name and address and I will post you some "Emmons type" locks