Billytaxi

[Donny Johnston]

That's funny, there's another player stays near you, Billyl he has a Sheffield as well, just got it as a matter of fact, maybe you can meet up, I believe his guitar has a slight bump on it. Shame. Welcome.

[Tony Russell Davis]

Donny, who you talking to? I can only see your post , but welcome to somebody anyway.Tony.

[billytaxi]

Donny. My wife and family were having a wynd up
At my expense My new Sheffield is as good as new.

[billytaxi]

Donny I'm looking for some kind of iPad
holder to fit on the leg of my steel
or if anybody may have some ideas on
this matter Thanks.

[Tony Russell Davis]

Hi - 22mm plastic pipe clips from Plumbcentre/B&Q/local hardware store etc. will probably fit the leg, they do on mine. Screw a piece of wood batten to that and, using small metal brackets, probably from the same supplier, fix a piece of board to the batten at the right angle. Paint will hide much! Thick laccy bands hold your device to that. If the board is thin, use short nuts and bolts.

Tony

[billytaxi]

ok Tony. cheers and Thanks

[billytaxi]

thanks for the info Tony ,works a treat

where can i get scale charts for e9 pedal steel

[Tony Russell Davis]

Glad that worked for you. Here's the next answer http://www.globalpursuits.ca/images/E9%20Fret_chord%20chart%2011X17.pdf Best wishes, Tony .
PS the copedent on the sheet is set out "ABC" but, as the charts only show the designation of the pedal/KL in use, it still works if your guitar is "CBA". Also it uses a vertical lever (B's to Bb) which is not an essential change and you might not have it. T.

[billytaxi]

OK Tony thanks again
Bill

[acerod]

Thought this was the section for welcoming new steelies. I see a couple who haven't been. So welcome all you new guys. Hope you get as much fun and enjoyment out of the Beasts as we do.