The British Steelies Society

Ok folks! here we go.

WTB 2 x BL710 or,..
2 x BL705 OR,..
2 x LXR16 on "MSA Millenium mounts"

And WTB kneelever kit + some bellcranks for a MSA Millenium (green/gray carbonfiber is what my kneelevers & guitar is)

private message or email [email protected]

thank you!

Jani, think the only place you will get knee lever kit in a particular colour would be from MSA themselves, if they had any left. Think most of the kits these days are polished aluminium, as the they no longer make the carbon bodied Millenium due cost.Contact Kyle or Mitchell at MSA to see if they can help, they might also have pickups as they are same fit as the currently produced Legend and Studio Pro models.

Jani, meant to add , what model Milly is it 1, 2 or 3? the undercarriage is different, so bell cranks differ.

Malcolm:

This is a M1 but it does have m2 and m3 bellcranks in it. This is Johnnt Cox's old guitar.
I was in contact with Kyle and they didnt have any pickups in stock there. But they asked me to send them pickups so they can install the slide mounts. ????
Well i have some aces in my sleve left . Weel se what we can dig up.

Jani, the M1 is the original model, bell cranks had collars in them to secure rods, mine was Ser no 9 ,( built by Johnny) and had these , but I had the undercarriage/ changer brought up to Later M3 standard at factory by Kyle and Mitchell, think yours may have been modified also,as Johnny's was also one of the early ones.I have Alumitone and Truetone on mine, prefer the Alumitone, similar sound to Truetone but a lot quieter on stages that cause interference from lights.

Malcolm

Mine has truetones and are to bright and sharp for my taste and thats why id need new pickups

Jani, just a thought, could you get some one to change pick ups round using the bases currently on your Truetones?

Malcolm.

Yes. id do it my self

but after all i could use pickups listed above so i could try and make mounts for them

pickups can be with widemount too