The British Steelies Society

Hi,
first post here but hopefully someone can help me.
Just got a Kline U12 that has been butchered in to a S10 - 3 pedals, 4 levers.
Will do a total overhaul but would like to add at least one pedal. Does anyone have or know of anyone that has parts for a Kline (levers, pedals, rods, anything).
All help much appreciated.

Daniel Levin / Sweden

[email protected]

He has almost everything in stock.

Wonderful!
Thank you very much!

My YouTube channel for KLINE's in action

https://www.youtube.com/channel/UC1GOVX ... iWs4fjb2dQ

Alan.

Nice playing!
You've got quit an impressive collection there.
Guess you can figure out which Kline I bought. It sure needs some attention, but not beyond what's doable. Running a music venue so I need a project during lock down ...
I was just getting ready to start machining some parts, but if Joe Kline still has some i guess I'll wait
Once again, thank you

Alan - you don´t happen to know what threading / screws that are used on the Kline keyless tuner?
It's apparently not metric threading, and my guess would på 1/8 unc
all best

All the American steel guitars that I've worked on use Imperial measurements (what was that war of independence for???) so you're right, you need to be looking for UNC taps and dies. A decent vernier or micrometer marked in inches and a thread gauge will help.
Good luck, Tony.

6-32 unc 1/4" long for strings 7-12. You can get small orders off eBay for about 3€. Strings 1-6 are 3/16" long.

Alan.