10 String changer

[Jimmy Gibson]

I know it’s a very long shot,but I am after a 10 string changer,or just one changer finger would be great,then I can get some more made.Any make will do,any help would be appreciated very much...Cheers..


Jimmy...

[Jimmy Gibson]

I would consider trading a very nice Roland Midi Guitar System for a good 10 string changer.



Cheers..Jimmy...

[Keyless12]

Jimmy, I've got 7 fingers from a Bennett. Similar to MSA 4 raise 4 lower. No lower springs for them. Perhaps Ronnie could supply the other 3? There's no grooving on them as they were never used. I'm still looking for a couple of front legs (any thread size) for my ZB rebuild, which might seem a fair swap. Dave.

[Jimmy Gibson]

Hi Dave,I may have one top section ZB leg with the clutch,any cut down mike stand inner leg would be ok for the lower section for the leg ,you are more than welcome to that,and a few quid on top for the changers.

Cheers...Jimmy...

[Keyless12]

That's good Jimmy. I'll definitely have that leg. I'm not too bothered about money as I can't see me using these and you may as well have them. I still have your address if it's the same in Saltash, so I'll post them off to you. I've just got to find another leg somewhere. Dave.

[Jimmy Gibson]

That’s very kind of you Dave,and let me have your address and I will send the leg,I may have another somewhere in the garage,If not I will see if I have a mike stand you can make a steel leg.What size plug are you using on the legs?


Cheers .Very much appreciated your help....Jimmy...

[Keyless12]

Thanks Jimmy. I can make a 3/4 inch thread plug if you find another leg or mic stand to match, do have a look to find one if you can. Here are my address details.
Dave Langdon
8 Avon Gardens
West Bridgford
Nottingham
NG2 6BP

[Jimmy Gibson]

Cheers Dave,and just to ask,I have a 1/8 “ left hand die if it is any good for you,also I may have some other odds and ends that may come in handy for you,I will see what I can find and put them in with the legs.


Cheers..Jimmy.

2 St Andrews Close
Saltash
Cornwall
PL12 4DF..

[Jimmy Gibson]

Hi Dave,I have found the leg,it is a bit pitted but should be ok,the clutch is fine and the plug is the same size that ZB used,the only mike stand I have is black,if you want it I will put it in with the other leg.

[Keyless12]

I won't be able to use the black stand as it won't match Jimmy, but any bits you find might be useful.